easytofix.homes+18312931196
All articles
Emergency Home Services5 min read

No Water in the House: Emergency Checks Before You Call

By EasyToFix Homes Team

Turning on a tap and getting nothing is one of the most unsettling home emergencies. The first few minutes matter, because a quick set of checks can separate a problem inside the house from a problem with the supply, and that answer decides who to call. This guide works through the checks in order, from the simplest to the most serious, so the water is back on as fast as possible.

1. Check whether the problem is the whole house

Start by testing more than one tap. Turn on a cold tap in the kitchen, a cold tap in a bathroom, and an outside tap if one is easy to reach. If only one tap is dry, the problem is local to that tap or that fixture, and the rest of the house is fine. If every tap is dry, the problem is in the main supply or the main valve, and the next checks focus there. Test both hot and cold, since a house with cold water but no hot water has a water heater problem, not a supply problem.

Listen as well as look. Turn on a tap and listen for air hissing, sputtering, or a short burst of water followed by nothing. Sputtering usually means air in the pipes, which can happen after the supply has been shut off and turned back on. A single short burst followed by nothing can mean a valve is partly closed or a pipe is blocked.

2. Check the main shutoff valve

The main shutoff valve controls all of the water entering the house, and it is the most common cause of a sudden total loss of water. The valve may have been closed by a family member, a worker, or a previous repair, and left closed by mistake. Find the valve where the main line enters the house, usually near the water meter, in the basement, or in a utility closet. Turn it fully open and test a tap again.

Check the individual fixture shutoff valves as well if only one area of the house is dry. Each toilet, sink, and appliance has its own small valve, and one of these can be closed by accident during cleaning or a repair. Related reading: /blog/shut-off-main-water-supply-before-plumber-arrives explains where the main valve is and how to close it safely in an emergency.

3. Check for a supply outage or a broken main

If the valve is open and every tap is still dry, the problem may be outside the house. Check with a neighbor to see if they have water. If the whole street is dry, the water company may have shut off the supply for repairs, and the water will return when the work is done. Check the water company website or call their outage line for an estimated return time.

A broken main on the property is more serious. Look for a wet patch in the yard, a sinkhole, or water running down the driveway when it has not rained. If the water meter is spinning fast while every tap is closed, water is escaping somewhere on the property, and the main valve should be closed at once. Related reading: /blog/main-water-shutoff-valve-location shows how to find and operate the main valve quickly.

4. Well water problems

Homes on a well lose water for different reasons. The well pump needs power, so a tripped breaker, a blown fuse, or a power outage stops the water at once. Check the breaker panel for a tripped breaker marked for the well pump and reset it once. If it trips again immediately, stop and call a professional, since the pump motor or the wiring may be faulty.

A dry well is a slower problem. A well can run low during a dry spell, after heavy use, or when the pump sits too high in the well. If the water returns after the house is left alone for a few hours and then runs out again after a short period of use, the well may be recovering too slowly. Do not keep running a dry pump, since it can burn out in minutes.

5. Frozen pipes and hidden leaks

In cold weather, a frozen pipe can block the water completely, and the blockage often sits in one section of pipe. If the water stopped during a cold night and some taps work while others do not, a frozen pipe is likely. Feel along the exposed pipes in the basement, the crawl space, and the garage for a section that is much colder than the rest. A frozen pipe may also bulge or show frost on the outside.

A hidden leak can also drain the supply, especially on a well system. A toilet with a faulty fill valve can run water constantly, and a slab leak under the floor can waste water where nobody can see it. Check the water meter, listen for running water when every tap is closed, and look for damp spots on floors and walls. A leak that is large enough to leave the house dry is an emergency, and the main valve should stay closed until a plumber arrives. Related reading: /blog/home-emergency-kit-every-household-needs lists the tools and supplies that help during a water emergency.

When to Call a Professional

Call a professional if the main valve is open and the neighbors have water, if the water meter spins while every tap is closed, if the well pump breaker trips again after a reset, or if a pipe has burst or frozen. A plumber can test the pressure, find a hidden leak, and repair a burst main without flooding the house. A well specialist is the right call for a dry well, a failed pump, or a pressure tank problem. Do not keep the main valve open while water is escaping, since the damage grows with every minute.

For emergency home help anywhere in the United States, call EasyToFix Homes at (386) 296-6181. A licensed technician can find why the water stopped, stop any leak, and restore the supply safely, day or night.

Tap to Call Emergency Dispatch(386) 296-6181