Carbon Monoxide Alarm Going Off: What to Do Right Now and What Never to Do
By EasyToFix Homes Team
A carbon monoxide alarm sounding in your home is an emergency until it is proven otherwise. Carbon monoxide is a colorless, odorless gas produced when fuel burns incompletely, and it can come from a furnace, a water heater, a gas stove, a fireplace, a generator or a car running in an attached garage. At low levels it causes headache, dizziness and nausea that are easy to mistake for flu. At higher levels it causes confusion, unconsciousness and death, often while people are asleep. An alarm means the gas has reached a level that the detector considers dangerous, and the correct response is measured in minutes, not hours.
Immediate steps when the alarm sounds
Move everyone, including pets, to fresh air outside the home immediately. Do not stop to open windows first, do not stop to investigate the furnace, and do not re-enter to collect belongings. Once outside, call 911 or your local fire department and report a carbon monoxide alarm activation. Fire departments carry meters that measure the gas level and can confirm whether the home is safe to re-enter. Stay outside until the fire department or a qualified professional clears the home, even if the alarm stops on its own, since a stopped alarm does not mean the gas is gone.
What never to do during an alarm
Never silence the alarm and stay inside, and never assume it is a false alarm because you cannot smell anything. Carbon monoxide cannot be smelled, and a detector that has alarmed has detected a real concentration, even when the cause is not obvious. Never restart a furnace, water heater or generator that may be the source, and never run a car in an attached garage to test whether the alarm sounds again. Never ventilate the home and then re-enter without a professional measurement, since ventilation can lower the reading temporarily while the source continues to produce gas.
Never ignore an alarm that stops after a short time. Intermittent alarms often mean an appliance produces carbon monoxide only under certain conditions, such as when a furnace runs for a long time on a cold night or when a garage door is left open with a car idling. That pattern is still dangerous, and it still needs a professional investigation. Replace the detector battery only after the home has been cleared and the cause has been found, not as a way to silence an active alarm. A detector that alarms repeatedly is reporting a problem, not malfunctioning, in the large majority of cases.
Common sources inside the home
Winter raises the risk, since furnaces run longer, windows stay closed and vents can be blocked by snow or ice. A home renovation that tightens the building envelope without adjusting combustion air can also create a backdrafting problem that did not exist before. Annual servicing of fuel burning appliances, including a heat exchanger inspection and a vent check, catches most of these problems before an alarm sounds. Related reading: /blog/what-to-do-if-you-smell-gas-at-home covers the related but different emergency of a natural gas leak, where the response also starts with leaving the home and calling for help.
False alarms, low batteries and detector types
It is true that detectors can chirp for a low battery, and that chirp is different from an alarm: a low battery chirp is a short, intermittent beep, usually once a minute, while a carbon monoxide alarm is a loud, repeating pattern of several beeps followed by a pause. Learn the difference before an emergency, since confusing the two in either direction is dangerous. A detector that chirps for a low battery should have its battery replaced promptly, and a plug in detector with a battery backup should be tested monthly with its test button.
Detectors have a limited life, typically 7 to 10 years, after which the sensor degrades and the unit should be replaced even if it still powers on. Check the manufacture date on the back of each detector and replace any unit past its end of life date. Place detectors outside each sleeping area and on every level of the home, following the manufacturer instructions, and never place a detector directly next to a fuel burning appliance, where normal startup emissions can cause nuisance alarms. A detector in the right location, replaced on schedule, is a reliable guardian.
After the emergency: finding and fixing the cause
Use the incident as a prompt to review the whole home. Confirm that every fuel burning appliance is serviced annually, that detectors are current and correctly placed, and that no generator, grill or car is ever operated inside or near the home. Related reading: /blog/power-outage-at-home-safety-steps covers generator safety during outages, when carbon monoxide risk rises sharply because generators are used more often and sometimes in unsafe locations. Prevention after an alarm is not optional: an alarm that sounds twice means the first investigation missed the source.
When to Call a Professional
Call 911 immediately when a carbon monoxide alarm sounds, and call a heating professional after the fire department clears the home to find and repair the source. Call a professional sooner, without waiting for an alarm, if fuel burning appliances have not been serviced in over a year, if a vent looks damaged or blocked, or if family members experience recurring headaches, dizziness or nausea at home that improve when away from the house. Those symptoms can indicate chronic low level exposure, which deserves investigation even without an alarm.
For emergency home help anywhere in the United States, call EasyToFix Homes at (386) 296-6181. An emergency specialist can advise on the immediate steps, arrange a qualified technician once the home is cleared, and explain the options and the cost before any work starts, day or night.